Technician on an orange stepladder reaching gloved hands into a ceiling opener, with loose wires and a red pull cord hanging below.

Technician kneeling in a blue cap, fastening a metal hinge plate to a gray ribbed door panel with a red drill.

Pair of cast metal cable drums, two coiled steel cables, locking pliers, a combination wrench and red-handled cutters on a wooden bench.

Garage Doors · London

Springs & Hardware

Counterbalance, track, roller, cable, and hinge work.

Call now · open 24/7(226) 270-3930

Request a visit

Which one do I need?

Since the cold snap the door has been stiff and noisy first thing, and after the last thaw the bottom corner began to…Garage Door Roller Replacement
On the old wood door, one hinge has pulled away from the panel, dragging a screw and a chunk of soft timber with it.Garage Door Hinge Replacement
You bought the house with a door that sticks near the top of its travel.Garage Door Track Repair or Replacement
The cable has wrapped itself around the shaft above the door instead of sitting on its drum.Garage Door Cable Replacement
You heard a sharp bang from the garage, and now the opener hums for a second and gives up.Torsion Spring Replacement
Open the door by hand and it drifts back down on its own, a little at first and then all at once.Extension Spring Replacement

Springs

Springs & Hardware

Torsion and extension springs, lift cables, drums and bearings. When any of these wears, the opener strains and the door becomes unpredictable. We restore the balance so everything else can relax.

Bigger photo, sooner job: Emergency Book soon Plan ahead

Which fix fits?

IfThe door hangs lower on one side and looks twisted in the opening.

ThenCable and drum reset.

One cable has usually slipped off its drum; the door needs to be secured before it is re-seated.

IfA roller has popped out and the panel is leaning away from the track.

ThenOff-track door reset.

We lift the section back into the track and look for what forced the roller out.

IfA bracket has pulled away from the wall and the track wobbles.

ThenTrack re-anchoring.

Fresh lag bolts into solid framing, and a check that the track spacing is still correct.

IfOn bright mornings the door will not close, then by lunchtime it behaves itself.

ThenPhoto-Eye Sensor Alignment or Replacement.

By the end of the visit you have a door that closes from every control and reverses the instant the beam is broken, a sensor pair mounted level at the right height with steady indicator lights, wiring that is secured…