Paneled garage door leaning on its side against a wall, with one section on sawhorses and a tool bag on the floor.

Technician on an orange stepladder reaching gloved hands into a ceiling opener, with loose wires and a red pull cord hanging below.

Technician kneeling in a blue cap, fastening a metal hinge plate to a gray ribbed door panel with a red drill.

Garage Doors · London

Repair & Maintenance

Inspection, adjustment, sealing, and section-level repairs.

Call now · open 24/7(226) 270-3930

Request a visit

Which one do I need?

Backing out in a hurry, the bumper tapped the bottom section.Garage Door Safety Inspection
On windy nights the door rattles in its frame, there is a line of daylight along one side, and the bottom seal has gone…Garage Door Tune-Up
The morning after a thaw the opener groaned, the door stayed stuck to the icy floor for a second, then lurched up…Off-Track Garage Door Reset
Rust has crept along the bottom edge of the lowest section.Garage Door Panel Replacement
The strip under the door has gone as hard as a hose left out for ten summers.Garage Door Bottom Seal Replacement
Dry leaves keep appearing in the same corner inside the garage, and this fall there were mouse droppings along the wall…Garage Door Perimeter Weatherstrip

Repairs

Repair & Maintenance

Doors wear from the bottom up. The seal along the floor hardens, the lowest rollers pick up grit, and the bottom brackets take the salt. Repair and maintenance work starts with those parts and follows the wear upward through hinges, tracks and the panels themselves.

Bigger photo, sooner job: Emergency Book soon Plan ahead

Which fix fits?

IfThe door hangs lower on one side and looks twisted in the opening.

ThenCable and drum reset.

One cable has usually slipped off its drum; the door needs to be secured before it is re-seated.

IfA roller has popped out and the panel is leaning away from the track.

ThenOff-track door reset.

We lift the section back into the track and look for what forced the roller out.

IfA bracket has pulled away from the wall and the track wobbles.

ThenTrack re-anchoring.

Fresh lag bolts into solid framing, and a check that the track spacing is still correct.

IfOn bright mornings the door will not close, then by lunchtime it behaves itself.

ThenPhoto-Eye Sensor Alignment or Replacement.

By the end of the visit you have a door that closes from every control and reverses the instant the beam is broken, a sensor pair mounted level at the right height with steady indicator lights, wiring that is secured…